Forum Navigation
Post History: Adam Backer
Quote from Trond Arvid Røsvik on August 9, 2022, 4:38 am
I use currently the VE-CAN port only, se …In: Wakespeed on gx touch screen
5 months ago
Update:
Well, the documentation seems a little misleading here. The cables with label:
(10) B …In: WS500 bench test
5 months ago
I turned the MP3k back on and it did eventually begin to ramp down, however my cells were drifting a …In: REC ABMS not recharging after reaching full charge
5 months ago
And to test powered up, you need to have your battery + and - connected as well
Just to m …In: WS500 bench test
5 months ago
Sorry, I tried to format the above for best readability, but it seems some of the styling did not ta …In: REC ABMS not recharging after reaching full charge
5 months ago
Hello,Â
Today I updated my REC ABMS to 2.8 software. At the time, my pack was measuring around 72% …In: REC ABMS not recharging after reaching full charge
5 months ago
Update: I received an updated 2.8 firmware for ABMS from Tine today, and it included a 2.8 manual wh …In: REC Pre-Charge module manual and/or wiring diagram
5 months ago
Hmm.. I read this, did the math, and double checked my settings but I still do not understand why it …In: REC ABMS not recharging after reaching full charge
5 months ago
Hello,
Today I went to wire up my pre-charge module and noticed that the diagram in the latest RE …In: REC Pre-Charge module manual and/or wiring diagram
5 months ago
75.9% today, 13.27 volts, still no charging occurring ;(
Also looks like I forgot to mention I am …In: REC ABMS not recharging after reaching full charge
5 months ago
I found this video from wakespeed where they show only plugging in the USB cable. This worked for m …In: WS500 bench test
5 months ago
For the record, I did experience this a little bit after my upgrade, some of the values I entered wo …In: REC BMS WiFi firmware update 1.6 now released
5 months ago
I am trying to power on my WS500 to check firmware version, upgrade, and configure via my android.
…In: WS500 bench test
5 months ago
ahoy!
I convinced myself that the balmar 618 was a waste of time and received the WS500 kit today …In: WS500 sensors & REC BMS
5 months ago
Hello, My system has been setup for a few days, and it is either not re-entering charge mode, or I d …In: REC ABMS not recharging after reaching full charge
5 months ago
Hello, I was reading this thread on victrons forum and have a couple questions. It looks like my BM …In: Active BMS latest firmware?
5 months ago
