Rudder Adapter YDRA-01
The NMEA 2000 Rudder Angle Adapter YDRA-01 allows you to connect an existing resistive type rudder angle sensor installed on a rudder and supply NMEA 2000 autopilots, chart plotters and other devices with the rudder angle. Can be used with a rudder angle sensor with maximal resistance less than 400 Ohm, including EU or US standard sensors, and with 0-5V voltage output sensors. The Adapter can work in parallel with an existing analog gauge.
The NMEA 2000 Rudder Angle Adapter YDRA-01 allows you to connect an existing resistive type rudder angle sensor installed on a rudder and supply NMEA 2000 autopilots, chart plotters and other devices with the rudder angle.
The Device can be used with a rudder angle sensor with maximal resistance less than 400 Ohm, including European (10 to 180 Ohm range) or American (240 to 33 Ohm range) standard sensors, and with 0-5V voltage output sensors.
The Adapter can be installed as a standalone measuring device, or work together with a digital gauge, or in parallel with an existing analog gauge (2-coils and 1-coils gauges are supported, see Picture 2). If you have a combined gauge where you choose the value to display with a button, the Adapter will smoothly work with it, too.
NMEA2000 Micro Male, RayMarine Seatalk NG
Engine Gateway YDEG-04
Gateway for Volvo Penta, BRP Rotax, SmartCraft (Mercury, Mercruiser) and J1939 engines to NMEA 2000 marine electronics network. It will provide you with engine revolutions, motor hours, coolant temperature, battery voltage, warning and alarms, fuel rate and other data on the screen of your chart plotter. No extra cables required in most cases thanks to a built-in Y-connector.
The Thermometer performs measurements within the range from -55 to +125°C (-67..+257°F), the sensor is placed outside the case on a flexible, 95cm wire in a sealed stainless steel sleeve and can be used to measure the temperature of gases or liquids. If necessary, the wire can be elongated up to 100 meters. The Thermometer can be configured by the user to display data as “Air temperature”, “Sea temperature”, “Temperature in the refrigerator”, “Temperature in the engine room”, “Bait Well Temperature”, etc.
WIFI Gateway, Yacht Devices YDWG02
If you wish to see marine data from a smartphone, you should choose the Wi-Fi Gateway. It can join an existing Wi-Fi network on board or establish its own. It is also a bi-directional gateway, and can also convert NMEA 2000 to NMEA 0183 and vice versa for compatibility with outdated software. The Web Gauges page of the internal website allow viewing of realtime vessel data (position, depth, wind, course and speed, engine, etc.) using a web browser on PC, laptop, tablet or smartphone. This listing is for the item on the right that connects to your NMEA2000 network.
NMEA 2000 Bridge YDNB-07
Unifies two physical NMEA 2000 networks into a single logical network, smoothly exchanging messages between them. The Bridge also support filtering and processing of transmitted messages and contains a built-in compiler of a simple programming language. You can create message processing programs on any device with a MicroSD socket and a text editor. One of the CAN-interfaces on the device has high-voltage galvanic isolation and can operate at a higher supply voltage.