Rudder Adapter YDRA-01
The NMEA 2000 Rudder Angle Adapter YDRA-01 allows you to connect an existing resistive type rudder angle sensor installed on a rudder and supply NMEA 2000 autopilots, chart plotters and other devices with the rudder angle. Can be used with a rudder angle sensor with maximal resistance less than 400 Ohm, including EU or US standard sensors, and with 0-5V voltage output sensors. The Adapter can work in parallel with an existing analog gauge.
The NMEA 2000 Rudder Angle Adapter YDRA-01 allows you to connect an existing resistive type rudder angle sensor installed on a rudder and supply NMEA 2000 autopilots, chart plotters and other devices with the rudder angle.
The Device can be used with a rudder angle sensor with maximal resistance less than 400 Ohm, including European (10 to 180 Ohm range) or American (240 to 33 Ohm range) standard sensors, and with 0-5V voltage output sensors.
The Adapter can be installed as a standalone measuring device, or work together with a digital gauge, or in parallel with an existing analog gauge (2-coils and 1-coils gauges are supported, see Picture 2). If you have a combined gauge where you choose the value to display with a button, the Adapter will smoothly work with it, too.
NMEA2000 Micro Male, RayMarine Seatalk NG
3kW DC-DC Energy Management System
$2,499.95Add to cart
• Charge higher voltage batteries utilizing existing chassis electrical system.
• On demand supplemental chassis electrical system power to support surge loads without
cost of additional batteries.
• Replace existing chassis alternator with higher energy unit and transparently support legacy
chassis power bus.
• J1939/RV-C based CAN support for system and BMS integration.
• Compatible with additional WS500 controlled alternators installed in same system
Humidity Sensor YDHS-01
Provides chart plotters and instrumental displays with humidity and air temperature measurements and calculated dew point temperature. High quality sensor with ±2 % RH and ±0.3 °C accuracy in most of the operating range. The device is plug and play; you only need to plug it into a NMEA 2000 backbone to get readings on all chart plotters and instruments on board.
The Thermometer performs measurements within the range from -55 to +125°C (-67..+257°F), the sensor is placed outside the case on a flexible, 95cm wire in a sealed stainless steel sleeve and can be used to measure the temperature of gases or liquids. If necessary, the wire can be elongated up to 100 meters. The Thermometer can be configured by the user to display data as “Air temperature”, “Sea temperature”, “Temperature in the refrigerator”, “Temperature in the engine room”, “Bait Well Temperature”, etc.
NMEA 0183 Gateway YDNG-03
Allows you to connect NMEA 0183 equipment to a NMEA 2000 network and vice versa. It has a bi-directional converter with wide support of message types including AIS. The configurable baud rate from 300 to 115200 baud for the NMEA 0183 port allows connection of AIS transceivers (38400 baud), fast NMEA 0183 multiplexers and PC adaptors, as well as standard NMEA 0183 equipment.