Category: REC-BMS Battery Management Systems
REC-BMS Battery Management Systems
Showing 1–12 of 32 results
-
DS18B20 Additional REC BMS Temperature Sensor
$3.95Add to cartThe REC BMS is capable of supporting up to 8 Temperature Sensors. For the Q series you can purchase either a single (1D) sensor or the pre-wired 3D pack (3D). In addition you can parallel off additional temperature sensors. The REC BMS will simply read the address of the new DS as they announce themselves …
-
REC Wi-Fi module
$209.00Add to cartThe REC BMS Wi-Fi module allows you to control and monitor your BMS on your favourite browser using a Wi-Fi network in either a STA(Station) or AP(Access Point) configuration. Battery pack parameters such as voltages, current, temperatures, state of charge (SOC) and state of health (SOH) are displayed. It allows BMS settings and parameters setup, also used for BMS firmware updates. It fully replaces the PC Software BMS Master Control or BLE module. It also includes the wiring harness to connect an LCD touch display that can be used at the same time.
-
REC Active BMS
From: $329.95Select optionsActive BMS for 12V Systems. WS500 compatible. Be sure to include the custom wiring harness with cell &
relay wires, CAN and RS485 cables, temp. sensor wires (2), and remote ON/OFF switch, unless you are just replacing a unit or doing a custom installation. -
REC Victron CANBus Cable
$29.95Add to cartCAN DB9 to RJ45 (Victron Energy Pinout) This cable connects the REC CANBus to your Victron VE.Bus, allowing it to share data for load and charging control and allows BMS data to be displayed on your Victron network using devices like the Cerbo. As of July 1, 2021, the cable length has been increased to …
